SETTING UP THE HARNESS
A.
Put the restraint on a flat ground and supported from behind so that it will not tip over.
B.
Sit the child comfortably in position.
C.
Check the height of the buckle and adjust if necessary as detailed on page 21 and 22.
D.
Determine the desired headrest position, just above the child's shoulders.
E.
Remove the child and adjust the shoulder straps if necessary as detailed on page 22 and 23.
F.
Repeat steps A-D to confirm the correct set-up of the built-in harness.
ADJUSTING THE BUCKLE POSITION
The buckle needs to be positioned as shown. If the
buckle is too low it will be uncomfortable and needs
to be lengthened. See next page for adjusting to a
better position.
You must adjust the crotch strap to the correct length for your child before installing the restraint as it
cannot be adjusted in the car. The crotch strap should only be extended if the harness tongues are located
low against your child's legs, thus creating discomfort.
Always return the crotch strap to its shorter length when using the seat with a smaller child.
The buckle should always be positioned low down on your child's abdomen.
IMPORTANT :
Centre of button on buckle,
level with top of child's thighs
or just above (with all slack
removed from crotch strap.)
Buckle Position
OK
Centre Slot
Centre of
buckle above
the thighs
When replacing cover, ensure none of the harness straps are twisted and that all straps are secure by
pulling each harness strap.
IMPORTANT :
3. Longest Length
for larger child
2. Mid Length
for Mid size Child
Short loop
Long loop
B
1. Shortest Length
for smaller size child
20
21
Cover
Body
3- bar slide
HOW TO USE
HOW TO USE
ADJUSTING THE CROTCH BUCKLE HEIGHT
The seat has the crotch straps fitted in the shortest length
position as supplied. The crotch buckle height can be adjusted
by threading the 3 bar slide into other slot configurations.
A.
Lift trim cover to reveal crotch strap slots and the 3 bar slide.
B.
Turn the crotch 3-bar slide and push through each slot as
shown right until the Crotch strap assembly through the slot.
Turn the seat over to access the 3 bar slide underneath the
seat.
C.
Having released the 3 bar slide this forms the longest length. If a mid-length
is required, take the 3 bar slide from an outer slot and feed through the
centre slot by turing the 3 bar slide on its side to form a short loop. See 2
below.
D.
Repeat steps A,B and C and leave the 3 bar slides underneath the seat to
achive the highest crotch strap length. See 3 below.
E.
Refit the cover.
F.
Pull the crotch buckle upwards to remove slack.
G.
Check the buckle height on the child's thighs.
Centre slot
3 Bar Slide
