08
www.babylove.com.au
12. TO FOLD THE STROLLER
A.
Engage the brake.
B.
Place the backrest into the fully recline position.
Fold the canopy back.
C.
Pull up on both frame release latches located near
the top of the handle tubes. Pull up far enough for
the frame to release.
D.
The frame will fold down. Apply the storage latch.
E.
Adjust the position of the front wheels if necessary
to accommodate compact folding.
C
D
D
05
6. TO USE THE BRAKE
A.
Press down on the brake lever to lock.
B.
Lift up to release brake.
7. TO SECURE YOUR CHILD IN THE HARNESS
WARNING: Use this harness at all times.
A five-point harness is provided to restrain your child. To
secure the child in the harness, push buckle (A) and (B)
into the buckle housing (C) until the buckle prongs snap
into position. Carefully adjust the harness by pulling
the slider (D) until the desired fit is achieved in the lap,
shoulder and crotch straps. Always adjust the harness
when changing the seating position of the child. To
release the buckle, squeeze the top and bottom prongs.
8. USING THE TETHER STRAP
WARNING: Use the tether strap to prevent the stroller
from rolling away.
NOTE: A tether strap is fitted to this stroller, place the
loop over desired wrist when using the stroller.
A.
Should you need to change wrist, remove the
tether strap and apply to the other handle. To
ensure a tight fit, loop the tether strap around
rather than over the handle. Open the end of the
tether strap and insert the opposite end through
the opening created. Pull until tether strap
tightens around handle.
www.babylove.com.au
A
B
