BaBylissPro FX685E, Руководство пользователя

Страница: 8 / 72

8
closeness of the cut; from a close
cut with the taper lever in the up
position - to a longer length cut
with the taper lever in the down
position.
• T here are 5 dif ferent t ap er
positions to choose from. To
increase cutting length, slowly
push lever down. To cut closer
push the lever up (figure. 1).
• Because a different cutting edge
is used in each setting, using the
taper lever lengthens the life
of your blades. Packed-in hair
can slow down any clipper. To
remove hair without removing
blades, keep the clipper on, and
quickly push the taper lever back
and forth from close to longer cut
several times. If you do this every
time, especially after heavy hair
cutting, the blades should remain
free of hair.
• T h i s q u a l i t y h a i r c u t t i n g
i n s t r u m e n t h a s b e e n
manufactured with extreme care.
It has been thoroughly tested
and inspected before reaching
the professional user. As with all
precision instruments, there may
be a period of “breaking in”.
• If the speed of the motor varies,
(as indicated in a change in sound
or pitch), it may be an indication of
a fluctuation in line voltage. Refer
to the ‘Power & Vibration Screw’
section in this booklet for more
information on how to maintain
optimum performance.
• When the clipper is lubricated and
adjusted in accordance with the
instructions, it will deliver ample
power and speed for professional
hair cutting requirements.
IMPORTANT
Blades must be
cleaned and oiled on a regular basis
for proper functioning. Failure to
regularly clean and oil the blades
will void the warranty.
MAINTENANCE OF THE BLADE
Always apply oil to the blades
before use. This will ensure
maximum cutting performance.
With the clipper switched on, away
from your body in a downward
position, apply oil onto the top of
the blade. Turn clipper off and wipe
off excess oil with a soft dry cloth.
REPLACEMENT AND REMOVAL
OF FX685E BLADE SET
To remove the blade: turn the
clipper to the off position and
unplug from mains supply.
To replace the blade after removal
for cleaning, replacement, or
because they are out of alignment:
• Place the moving blade onto the
plastic oscillating head.
• Next, you must make sure that the
two blades are properly aligned.
• Line up the non-moving blade
with the two screw holes.
• Replace the original screws, and
lightly tighten. Then align the two
blades up, point to point, as per
figure 4 below.