BFS1A CORDLESS SINGLE
FOIL SHAVER
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances,
especially when children are present, basic
safety precautions should always be taken,
including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
1. Always turn appliance off immediately
after using.
2. Do not place or store appliance where it
could fall or be pulled into a tub or sink.
3. Do not use appliance while bathing or in
the shower.
4. Do not place appliance in, or drop into
water or other liquids.
5. Turn appliance off before cleaning.
6. Non-rechargeable batteries are not to
be recharged.
WARNING -
To reduce the risk of burns,
fire, or injury to persons:
1.
Never leave appliance on while
unattended.
2. Close supervision is required when this
appliance is used by, on, or near children,
or persons with limited physical, sensory,
or mental capabilities or invalids.
3.
Use appliance only for its intended
use as described in this manual. Use
only attachments recommended by the
manufacturer.
4.
Never operate the appliance if it has
been dropped or damaged, or dropped
into water. Return the appliance to
negative end of each battery first so it
will slip easily into place.
3. Return the metal housing by sliding it
over the plastic inner housing until it
clicks into place.
4. To use your shaver, push ON/OFF switch
upward to the ON (I) position.
5. After you finish using your shaver, push
down on the ON/OFF switch to turn the
shaver OFF (O).
6. Remove the batteries if the batteries are
no longer functional or if the shaver is
left unused for an extended period of
time.
7.
Clean the battery contacts and also
those of the device prior to battery
installation.
8. Remove used batteries promptly.
9. Always purchase the correct size and
grade of battery most suitable for the
intended use.
10. Replace all batteries of a set at the
same time.
11. Do not mix old and new batteries. Do
not mix alkaline, standard (carbon-
zinc), or rechargeable (nickel cadmium
or nickel metal hydride) batteries.
ON/OFF SWITCH
To operate, simply slide switch to the ON (I)
position. To stop operation, set to the OFF
(O) position.
VERY IMPORTANT: Cutters must be
cleaned and oiled on a regular basis for
proper functioning. Failure to regularly
clean and oil the cutters will void the
warranty.
a BaBylissPRO Service Center for
examination and repair.
5.
Keep the appliance away from heated
surfaces.
6. Never drop or insert any object into any
opening on the appliance.
7.
Do not place the appliance on any
surface while it is operating.
8.
Do not use this appliance with a
damaged or broken foil or cutter, as
injury to skin may occur.
9.
Do not use the appliance outdoors
or where aerosol (spray) products are
being used or where oxygen is being
administered.
10. Do not crush, or heat above 100°C or
incinerate the appliance, due to risk of
fire, explosion or burns.
Keep the appliance dry
CORDLESS METAL SINGLE FOIL
SHAVER BFS1A
OPERATING INSTRUCTIONS
MPORTANT:
This shaver has been
engineered to give you a clean, close,
smooth shave. It requires 2 AA batteries
(included). We recommend using longer-
lasting alkaline batteries in your shaver. If
you are not going to use your shaver for a
long period of time or if the batteries are
dead, remove or replace the batteries from
the unit.
1. Remove the metal housing by sliding the
bottom switch over and pulling the cover
off.
2. Align the 2 AA batteries with the positive
and negative positions indicated inside
the battery compartment. Being careful
not to bend the springs, insert the
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily
irritated by shaving, or who suffer from
a skin allergy, should test one section on
the leg or arm before using the shaver.
2. Remove the protective cover and turn on
the unit to start shaving. Hold the shaver
at a right angle to the area that you want
to shave and run the double shaving foil
carefully along your skin. Tip: In general,
we recommend that you shave against
the direction of hair growth, as this is the
best way to trim the hair. Pull your skin
tight, with your fingers in inaccessible
areas, to achieve optimum results.
3. Switch the shaver off each time after
shaving and clean it.
4. Do not push the shaver on the skin too
hard as it could cause irritation, make
the shaver warm and prevent a perfect
shave.
5. Please note that it takes 2 to 4 weeks for
your skin to adapt to a shaver, so please
do not change shaving instruments in
this period of time.
6. If hair is longer than 1mm begin by
cutting the hair down first with a
trimmer, than use shaver for a smooth
close shave.
USER MAINTENANCE INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Do not remove the shaving foil unit while
the shaver is switched on. Always switch
the shaver off!
Ensure that no water gets into the inside
of the shaver.
Never press on the cutting blades or the
shaving foil and do not touch them with
hard objects as this can cause irreparable
damage to the shaver or parts.
2
3
Содержание FOILFX 01
Страница 6: ...10 11...
