IMPORTANT NOTe:
The top edge of the fixed blade must be a minimum of 1/32"(1 mm) higher than the top
edge of the moving blade as centered as possible. This is important so that the moving
blade does not come in contact with the skin.
Be sure to add a few drops of BabylissPro lubricating oil to the blades before running.
Don’t forget to tighten the screws after the blades have been aligned.
uSeR–MAINTeNANce INSTRucTIONS
MAINTeNANce OF THe BLADe
Always apply oil to the blades before, during and after use. This will ensure maximum
cutting performance and proper maintenance. Hold the clipper away from your body in
a downward position, and apply a drop of BabylissPro lubricating oil on the front and
sides of the cutter blade. Wipe off excess oil with a soft dry cloth.
Do not pull, twist, or wrap the supply cord around the appliance.
HOW TO uSe cuTTING GuIDeS
To use the comb attachments, turn the clipper to "O-OFF" position.
Slide the comb attachment onto the top of the clipper blade, and then
pull down and over the back of the blade. To remove, pull up on the
back of the comb attachment and then pull away from the blade.
RePLAceMeNT (ReMOVAL) OF BLADe SeT
Step 1. Unplug the unit and adjust the taper lever (see illustration A).
Step 2. Remove the screws and the fixed blade. Save the screws.
Step 3. Lift off the small moving
blade (with white blade
driver), replace it with a
new one. Align the spring
with the spring hole and
accommodate the metal
driving pin into the slot
from the white blade driver
(see illustration B).
Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust the
teeth as shown in illustration C, to a gap of 1/32" (1 mm) to 1/16" (1.5 mm)
and the small moving blade as centered and parallel as possible to the fixed
blades teeth.
BLADe SHARPeNING (MODeL BAB604Rc)
BabylissPro cutting blades are ground from the finest quality steel with carbon and
are hardened to extend the cutting performance. As with any cutting appliance, the
cutting edges become dull from repeated usage. Increasing blade tension to force
the blade cutting that would cause the clipper to overheat and reduce its motor life.
When the blade no longer cuts smoothly, sharpening is required or replace it with new
BabylissPro blade set (model BAB604RC).
C.
Fixed Blade
1/32" to 1/16"
Small
Moving
Blade
A.
Spring Hole
Taper Lever
White Blade Driver
Metal Driving Pin
B
BAB880C IB-13_279A.indd 7-8
2/2/15 11:30 AM
