6
CLIPPER
E929XDE/E929YDE
.
2 motorised cutting guides
for continuous adjustment
‘Red’ guide = from 3 to 15mm
‘Green’ guide = from 18 to
30mm
2.
1 precision guide
5 positions (0.5 to 2.5mm)
3.
Blades:
Moveable blade:
- Sharpened using 3D etching
process: for an exceptionally
sharp cutting edge.
-
Long-lasting organic CARBON
HLD
(Hard Like Diamond)
coating: ultra-hardwearing and
00% stainless steel blade.
Fixed Blade:
-
Titanium coating
: for longer
life.
These two technologies provide
perfect surface condition and their
combination is optimal for reducing
the friction coefficient.
4.
Thinning function
5.
ON/OFF switch
6.
Cutting length adjustment
7.
LED display of selected length
on graduated screen:
Red LED on the left scale
for the red guide (from 3 to
15mm)
Green LED on the right scale
for the green guide (from 18
to 30mm)
8.
Charging indicator light
9.
Plug for use on the mains and
for charging
0.
Cleaning brush
CHARGING THE CLIPPER
Before using the trimmer for the
first time, allow it to charge for 6
hours.
. Connect the transformer to the
mains and the plug into the
unit.
(Fig. 1)
2. Check that the charging
indicator light is lit and that the
switch on the trimmer is in the
OFF position.
3. A fully charged trimmer will run
for 30 minutes.
MAINS USE
Connect the transformer into the
mains, wait minute and then
switch into the ON position.
IMPORTANT! Use only the
transformer provided with the
E929XDE/E929YDE clipper Voltage
= 2,4V - Tension = 000mA
USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the
cutting guide BEFORE turning the
trimmer on, and turn it off before
changing the guide.
To attach the cutting guide, first
adjust the cutting length to 3mm
and push on the guide until you
hear a ‘click’.
(Fig. 2)
To remove the cutting guide, first
adjust the cutting length to 5mm
or 30mm and push up on the
ENGLISH