current device (RCD) with a rated residual operating
current not exceeding 30mA is advisable in the electrical
circuit supplying the bathroom. Ask your installer for
advice.
•
WARNING!
Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
• Do not immerse the appliance into water or other liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
discontinue use immediately. Contact the Conair
Customer Care Line (refer to ‘UK After Sales Service’
section for further information).
• Do not use the appliance if the lead is damaged. In
the event of damage, discontinue use immediately.
If the lead is damaged it must be replaced by the
manufacturer. Return the appliance to the Customer
Care Centre (refer to ‘UK After Sales Service’ section
for further information). No repair must be attempted
by the consumer.
• Do not leave the appliance unattended when switched
on or plugged in.
• This appliance is equipped with a safety thermostat. In
the event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the appliance to the ‘0’ position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear filter is clear of hair and other debris.
