BaByliss BIG HAIR 2775U, Инструкция по эксплуатации

Страница: 3 / 10

even if the appliance is switched off. For additional
protection the installation of a residual current device
(RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
WARNING!
Do not use this appliance near water
contained in basins, bathtubs or other vessels.
• Do not use this appliance in the bathroom.
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the
appliance has been dropped. In the event of damage
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information).
• Do not use the appliance if the lead is damaged. In
the event of damage contact the Conair Customer
Care Line (refer to ‘UK After Sales Service’ section for
further information).
• Do not leave the appliance unattended when switched
on or plugged in.
• This appliance is equipped with a safety thermostat.
In the event of overheating the appliance will stop
automatically. Should this happen, push the speed
switch on the handle to the “0” position to switch off,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear filter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug. Contact the Conair Customer Care Line (refer
to the ‘UK After Sales Service’ section for further
information).