UV-DISINFECTING CAP KILLS
99.9% OF BACTERIA. BASED
ON TESTING OF
E. COLI,
STAPHYLOCOCCUS AUREUS,
AND PSEUDOMONAS
AERUGINOSA
WHEN USED
IN ACCORDANCE WITH
DIRECTIONS FOR USE
BELOW.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING –
Polythene bags over product
or package may be dangerous. To avoid
danger of suffocation, keep this wrapper
away from babies and children. This bag
is not a toy.
When using electrical appliances,
especially when children are present, basic
safety precautions are required to always
be followed, including the following:
SAFETY CAUTIONS
• For the purposes of recharging the
battery, only use the adaptor provided
with this appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
• Keep oil out of reach of children.
• Children should be supervised to ensure
that they do not play with the appliance.
• The battery is not replaceable.
• This appliance contains batteries that are
only replaceable by skilled persons.
• The appliance is only to be used with
OPERATING INSTRUCTIONS
1. Before using the shaver cordless for
the first time, charge continuously for
4 hours. Maximum battery capacity
will only be reached after 3 charging
and discharging cycles. A full charge
will provide over 5.5 hours of use.
2. Make sure the switch on the shaver is in
the OFF (O) position.
Connect the standard charging cord
(included) into the standard port on the
bottom of the shaver. Plug the adaptor
into any electrical outlet (at the voltage
listed on the label affixed to the adaptor).
If using the USB-C port for charging,
make sure shaver is turned off and plug
USB-C cable into the USB-C port at the
bottom of the shaver.
Charging indicator will light up to
indicate that the charging has begun.
Charging is complete after 4 hours.
BATTERY/CHARGING INDICATOR
(BOTTOM OF SHAVER)
Blue Flashing – Charging
Blue Solid – Charge Complete, Fully Charged
3. The adaptor may become warm while
charging. This is normal.
4.
Preserving the battery: In order to
maintain the optimum capacity of the
rechargeable battery, the shaver should
be recharged for 4 hours approximately
every 6 months.
5. Make sure the switch is in the OFF
(O) position when the shaver is not
operating.
6. Only use the adaptor (CA78M) supplied
with this appliance.
the power supply unit provided with the
appliance.
• The appliance must only be supplied at
Safety Extra Low Voltage corresponding
to the marking on the appliance.
• Do not immerse into water
or other liquids. Do not use
near basins or other vessels
containing water.
• Store out of children’s reach.
• If the supply cord is damaged, it must be
replaced by a special cord or assembly
available from the manufacturer or its
service agent.
•
Return the appliance to the nearest
service facility for examination, electrical
or mechanical adjustment or repair.
• Avoid skin contact with moving blade.
• Always ensure that the voltage to be
used corresponds to the voltage marked
on the unit.
• For additional protection, the installation
of residual current device (RCD) with a
rated operating current not exceeding
30mA is available in the electrical
circuit supplying the bathroom. Ask your
installer for advice.
•
Do not use the appliance if it has
been dropped or if it shows noticeable
damage.
• Do not leave unattended when switched
on and always allow to cool before
storing away.
• Do not use any attachments other than
those recommended by BabylissPRO.
WARNING: Keep the appliance dry
This symbol
indicates there is a
detachable power supply.
WARNING:
If the charging light suddenly
starts to flash rapidly, the appliance is
faulty. If this happens, stop charging,
remove the adapter from the outlet and
contact our Customer Care Center for
further advice (see the Warranty section of
this information booklet).
FOR DIRECT PLUG-IN OPERATION
Make sure shaver is turned off. Connect
standard charging cord into the standard
port at the bottom of the shaver. The
shaver will not operate directly plugged in
via USB-C. Direct plug-in operation is only
possible through the standard charging
cable, not USB-C.
ON/OFF SWITCH
To operate, simply slide switch to the ON (I)
position. To stop operation, set to the OFF
(O) position.
UV DISINFECTING CAP – DIRECTIONS
FOR USE:
BLUE UV LOGO
(TOP CAP OF SHAVER)
BLUE LED ON – Sanitizing in Process
BLUE LED OFF – Sanitizing Complete/Unit Off
1. Close the cap and the sanitizing process
will immediately start. The lid must be
fully closed for the UV-sanitizing process
to begin. The blue UV light indicator
will illuminate indicating the ultraviolet
sanitizing process is in operation.
2. Wait 3 minutes for the cycle to complete.
The blue light will turn off when the cycle
is done.
2
3
