BaByliss PRO Titanium Foil Shaver, Руководство пользователя

Страница: 4 / 9

WEEE available in your area. In this way, some materials
can be recycled, re-used or recovered.
• By ensuring this product is disposed of properly, you will
help prevent potential negative consequences for the
environment and human health due to possible content
of hazardous substances.
For more detailed information about the disposal of this
product, please contact your local household waste
disposal service.
PREPARATION FOR USE
General
• Always inspect the appliance before use to ensure the foils are free
from hair, debris etc.
• Always ensure hair is clean and dry before shaving.
INSTRUCTIONS FOR USE
Charging the Appliance
• Before using the appliance for the first time, charge the battery
continuously for 3 hours. Maximum battery capacity will only be
reached after 3 completed charging and discharging cycles.
• Plug the charging adapter into a suitable mains power socket
and switch on. The blue LED indicator light will flash when correctly
connected to the mains power and will continuously flash until the
battery has fully charged. When the battery is fully charged the LED
indicator light will stop flashing but remain on.
NOTE: Before charging, ensure the shaver switch is in the (0) OFF
position.
• When the shaver is running low on charge, the LED indicator light
will flash, warning there is approximately 3 minutes of battery use
remaining. A 3 hour charge will provide approximately 180 minutes
use. A 30 minute quick charge will provide approximately 30 minutes
use.
• If the charging light starts to flash rapidly (more than 4 flashes per
second) then the appliance is faulty. If this happens then please stop
charging and remove the adapter from the mains and contact the
Conair Customer Care Line. (See ‘UK After Sales Service’ section for
further information).
Preserving the Batteries
• In order to maintain the optimum capacity of the rechargeable
batteries, the appliance should be recharged for 3 hours
approximately every 3 months.
• Using the shaver on the mains - ensure that the shaver is switched
off. Plug into a suitable mains socket. Wait for approximately a
minute, and then switch on.
IMPORTANT: Do not use the shaver in this mode for more than 20
minutes.
Oiling Instructions
• For optimum cutting performance, it is highly recommended
to oil the cutting blades after every use.
• When using the oil for the first time, unscrew the cap and
cut off the very end of the plastic tube with a pair of scissors.
• Remove the foils and switch the appliance on.
• Holding the shaver at a 45 degree angle, gently squeeze
the oil tube and apply 1 drop directly onto the cutter blades.
• Leave the unit on for a further few seconds to allow the oil to
thoroughly spread along the length of the blades.
• Switch off the unit and remove any excess oil by gently dabbing with
a cloth before using on hair.
• Replace the foils over the cutting blade.