Assembly
A: Rear wheel assembly
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1. Install the front fork and head pipe:
insert the front fork (part4) into the front end of the frame (part9); rst
install the small basket (8), then insert the head pipe (5) into the frame, as
shown in the photo xed with screws and nuts.
2. Install the front wheel:
as shown in the photo, the front wheel component (6) is inserted into the
front fork (4), xed by screws and nuts.
3. Install the steering wire:
insert the steering wire (10) tip into the edge of the front fork (4) steering
iron, the back end of steering wire xed with screw on the iron sheet
below the frame (9).
4. Install rear wheel:
Insert the rear wheel component (7) into the plastic component in the
rear end of the frame (9), Press the red button as photo shows until the
rear axle is locked.
5. Install push handle:
Put the push handle component (12) of the plastic part on prominent
iron at the bottom of the frame (9), insert the push handle (12) short
steering rod in the plastic parts from the bottom, set the screw into the
push handle (12), then insert the push handle of the long steering rod
into the short steering rod, x with screw, lock the screw.
6. Install protective safety bar:
as photo shows, insert the protective safety bar (3) respectively in the
plastic parts on both sides of the seat cushion (2), x with screw nut.
7. Install seat cushion:
place the seat cushion (2) in the frame (9), x with screw.
8. Install cotton pads and safety belts:
open the front wall of the backrest (3) , the front end of the cotton pad
(11) is sheathed in the front wall, the back end of the cotton pad (11) is
sheathed on the backrest (3), close button. In the seat cushion (2) and
backrest (3) are left the seat belt hole, rst the safety belt wear in
manhole, then at the end of the belt set up a small piece of plastic that
we have provided for you. After the completion of the installation effect
as shown in photo.
9. Install basket:
The basket (13) is set in the push handle (12) and the frame (9) as shown
on the photo.
10. Install canopy:
set the canopy (1) in the plastic parts on both ends of the backrest (3). As
shown in the photo.
