Babyauto Winy Savile V3, Инструкция по эксплуатации

Страница: 27 / 60

27 www.babyauto.com
5. INSTALLING CHILD SEAT. GROUP 2.
Use group 2 only from approx. 4 to 6
years of age (15-25 kg)
WARNING
1. From the base of the car seat, please change the R controller from
the base to the rear position by turning it on its axis (5.1).
2. Remove the harness, buckle and cushion as described in chapter
7 (5.2).
3. The seat must be in its most upright position to adjust reclining
angle of the child seat, pull the control red handle L towards you
until the desired position is achieved (5.3).
4. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (5.4).
5. Place the child in the child car safety seat, fasten the belt, ensuring
that the vertical belt goes through A guide and that the diagonal
shoulder belt passes through E guides under both armrests (5.5,
5.6, 5.7 y 5.8).
6. Insert the vehicle safety belt in the vehicle anchor point. You will
hear a “ click ” when properly installed, place the height adjuster Q
so that the belt is tight and guide the belt over the child’s shoulder
into the correct position (5.9 y 5.10).
7. Make sure the vehicle’s safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle’s
safety belt or prevent the installation of the seat in any way. To
release your child unbuckle the vehicle safety belt as described in
the instructions.
Ensure that the belt has no slack.
Group 0+/1/2
Make sure the vehicle’s safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle’s
safety belt or prevent the installation of the seat in any way. To
release your child unbuckle the vehicle safety belt as described in
the instructions.
Ensure that the belt has no slack.