Babyauto Winy Savile V3, Инструкция по эксплуатации

Страница: 26 / 60

26 SAVILE V3E
Ensure that the belt has no slack.
3. Install the child seat rearward facing, making sure it is firmly pressed
against the vehicle seat backrest (3.3).
4. Slide over the vehicle´s diagonal belt from the M guideway from the
rear upper seat and the abdominal belt by the guides I , under the
car seat making sure to pass it on the inside base R controller, so
that it remains fastened by this (3.4, 3.5 y 3.6)
5. Fasten the seat belt into the vehicle´s buckle until it “ clicks” , making
sure the child seat is properly installed ( (3.7).
4. INSTALLING CHILD SEAT. GROUP 1.
Only suitable for group 1 , approx.
9 months to 4 years of age (9-18 Kg.)
WARNING
1. From the base of the car seat, please change the R controller from
the base to the rear position by turning it on its axis (3.1).
2. The seat must be in its most upright position to adjust reclining
angle of the child seat, pull the control red handle L towards you
until the desired position is achieved (4.2).
3. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (4.3).
4. Pass the seat belt through both N guides behind the seat (4.4, 4.5 y
4.6).
5. Insert the vehicle safety belt in the vehicle anchor point. You will
hear a “ click ” when properly installed. (4.7).
6. Tighten the lap belt and diagonal shoulder belt, then place the red
safety clip T on the diagonal shoulder belt tongue as near to the
vehicle anchor point as possible without touching it! (4.8, 4.9 y
4.10).
Child restraint system
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (6.1).