(BB) 1/4" X 1-3/8" BOLT = 08 PCS
LOCK WASHER
PLAIN WASHER
HEXAGONAL NUT
STEP #2
MATTRESS SUPPORT ARM ASSEMBLY
STABILIZER RAIL ASSEMBLY
MATTRESS HEIGHT ADJUSTMENT
STEP #2.1
Lay Mattress Support flat with Stabilizer Rail on each side
Note:
On each end of the arm of the Mattress Support, there is a
hole for the bolt to pass through that corresponds to the
holes located in the frame of the Mattress Support.
STEP #2.2:
Insert the bolt into the desired hole of the frame through the
hole on the arm support. Fasten the bolt with plain washer,
lock washers & hexagonal nut provided. Repeat procedure
on other arms of the Mattress Support. Please see DETAIL B.
WARNING:
Set the Mattress Support to the desired height by adjusting
the Support Arms. The Mattress Support should be at its
highest setting for newborns, then adjusted to the lower
positions as the child grows and becomes mobile. Once the
child is able to stand, the Mattress Support should be at its
lowest position.
STEP #2.3:
Install the Stabilizer Rail at ends of the arm support as
illustrated on DETAIL C
10 X 70
OPEN WRENCH = 01
ALLEN WRENCH = 01
DETAIL B
DETAIL C
MATTRESS
NUT
PLAIN
WASHER
MATTRESS
BOLT
ALLEN
WRENCH
MATTRESS
BOLT
MATTRESS
BOLT
MATTRESS
BOLT
MATTRESS
BOLT
ALLEN WRENCH
OPEN WRECH
MATTRESS NUT
LOCK WASHER
PLAIN WASHER
MATTRESS SUPPORT
STABILIZER RAIL
Page 7 of 10
HARDWARE FOR STEP #2:
LOCK
WASHER
B
C
