Fig. 15
Fig. 14
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT
* To attach the Baby Trend Infant Car Seat, place the seat back in the
reclined position. Please see section entitled Seatback Positioning.
*
Check that the front child tray is firmly attached to the stroller
armrests.
Pull rearward on the rear edge of the front child tray
cover while lifting upward on the tray cover. Please see figure 14
and 15. Remove the tray cover and store in the basket of the
stroller.
* Position the Infant Car Seat, facing toward the rear of the stroller, so
that the seat shell goes into the front tray and latches into place.
Please see figure 16.
Check that the Infant Car Seat is firmly
locked onto the front tray before using.
The sides of the car seat
will rest on the fold joints.
* To remove the Infant Car Seat, squeeze the release handle located at
the foot-end of the seat and carefully lift upward on the seat. Please
see figure 17.
* The cover of the child/car seat tray may be fastened in the closed
position after your child outgrows the infant car seat. This will
prevent an older child from opening the child tray. To secure the
tray cover, remove the tray from the stroller as shown in figure 8.
Install the tray cover. Place the tray with the lid side down on a soft
flat surface. Remove the screw stored under the tray as shown in
figure 18. Insert the screw into the hole in the bottom of the tray
and into the matching hole in the cover. Tighten until snug. Do not
over tighten. If you wish to use the car seat tray function at a later
date (for a second child) remove the screw and store in the tray
bottom as before. Please see figure 18.
SEATBACK POSITIONING
* The seat has a multiple position recline that is controlled by a strap
and buckle assembly behind the seat. To recline the seat, loosen the
strap through the buckle and adjust to the required recline position.
Please see figure 19. To place the seat back in a more upright
position, press upward on the seat back with one hand while pulling
the straps through the buckle with the other. See figure 20. The strap
will lock automatically. Strap must go across slot on either side of
central seat body when adjusting seat back height. See figure 21.
Hole in tray to lock
down lid after car
seat use
Screw storage
bosses-factory
installed screws
for later use
Squeeze release handle
and lift upward
WARNING:
The upright position
should be used only for a child that is
at least 6 months old.
6
