49
50
11.0
Securing Child with Harness System
11.0
Securing Child with Harness System
8. Check that the straps are not twisted and
lie flat over the shoulders.
9. Tighten the harness straps to snugly
adjust harness around child by pulling
the Harness Adjuster Strap at the front of
the Car Seat as shown. (Fig 49-1)
10. Connect the Harness Clip and
position the Harness Clip at the middle
of the child’s chest, level with the
armpits.
12. Check Harness Straps - Make sure the straps are flat and snug
against the child’s shoulders and thighs.
NOTE: A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child’s flesh or
push the child’s body into an unnatural position.
Removing Your Child from Harness System
1. Open Harness Clip by pressing button and sliding apart.
2. Unbuckle the Harness Buckle by pressing the red button.
3. Press the Harness Adjuster Button and pull outward on the
straps to loosen.
4. Slide the harness straps off the child’s shoulders and arms.
5. Remove your child.
49-1
11.2 Adjusting Harness Strap Height
The Car Seat includes a sliding Adjustable Back that will adjust
the height of the harness straps as the back is adjusted.
1. The proper height of the harness
straps is at or just below your child’s
shoulders.
2. Rotate the knob behind the seat back
to raise or lower the moving seat back
and harness straps.
- To adjust the seat back height,
turn the moving back adjuster
knob behind the seat clockwise to
increase the seat back height and
counter clockwise to decrease the
seat back height. Each half turn will
raise or lower the slots 1/2”.
- Knob must remain in vertical position
after adjustment. (Fig. 50-1) DO
NOT use the Car Seat with the
Harness adjusted above the child’s
shoulders as the child will not be
held securely in a sharp turn, sudden
stop, or crash.
50-1
Knob handle must
be vertical
