37
38
10.0
Securing Car Seat in Your Vehicle
10.0
Securing Car Seat in Your Vehicle
Connectors (Fig 37-2) and pull base away
from the vehicle anchors.
2. Repeat on opposite side.
10.3 Base Installation with Vehicle Belt
WARNING!
DEATH or SERIOUS INJURY can occur:
• VEHICLE LAP BELT MUST BE TIGHTLY ADJUSTED AND
STAY TIGHTLY ADJUSTED AROUND CHILD RESTRAINT AT
ALL TIMES. IF VEHICLE BELT DOES NOT STAY TIGHT, READ
VEHICLE OWNER’S MANUAL AND “VEHICLE SEAT BELT
REQUIREMENTS” SECTION IN THIS MANUAL.
• PROPER RECLINE ANGLE FOR SEAT BACK RECLINE IS
REQUIRED. FOLLOW THE INSTRUCTIONS FOR ADJUSTING
RECLINE ANGLE USING SEAT ANGLE INDICATOR.
- TOO UPRIGHT CAN CAUSE A YOUNG INFANT’S HEAD
TO FALL FORWARD AND RESTRICT BREATHING.
- TOO RECLINED CAN CAUSE EJECTION IN A SUDDEN STOP
OR CRASH.
10.3.1 Initial Positioning
1. Follow instructions in Section 10.1 Preparation
for Installation in Vehicle.
37-2
37-1
UAS Release
Button
1 inch (2.54 cm). (Fig 37-1) If you find that
the UAS loosens or that the or the base
does not stay tightly secured, please see
Section 8.0 Selecting the Best Location for
the Car Seat to determine if the position you
have selected is adequate and check that
you have completed all of the steps in the
section entitled Securing the Car Seat or
Base in the Vehicle.
10.2.3 To Remove Base
Disconnect UAS Lower Connectors.
To disconnect the UAS Connectors:
1. Push base toward UAS connectors and
while pushing on the base, press the
UAS
Release Button on one of the UAS
