Baby Lock Tiara III BLTR16-3, Инструкция и справочник

Страница: 19 / 40

Page 18
Baby Lock Tiara III Instruction Manual
Threading the Machine
F
C
Take Up Spring
Tension Assembly
FRONT
BACK
A
B
Figure 11
1� Place a cone or spool of thread on the spool pin. If
using a spool, make sure that the slits on the spool
are against the base of the spool pin holder. Pass
the thread through the thread antennae eyelet from
back to front, continuing to thread guide A (Figure
11).
Page 12
HQ
18
Avanté User Manual
1. Place a cone or spool of thread on the spool pin.
Pass the thread through
the thread-mast eyelet from
back to front, continuing to thread guide A .
(Figure 11)
2. Continue to the three-hole thread guide B . Wrap
all three holes from back to front, hand wheel side to
needle side (see Figure 12).
Note: The purpose of the three-hole thread guide B
is to prevent loops of thread coming off the thread
cone from going into the top tension as a knot caus-
ing thread breakage and bad tension. For most
threads on a cone, it is important to thread all three
holes for consistent results and to make adjust-
ments at the top tension assembly. An exception to
this rule is when working with very delicate threads,
such as holographic or threads that are prone to
breakage, in which case you may try skipping one or
two holes on thread guide B.
Threading the Machine
B
C
D
E
A
BACK FRONT
2
TENSION ASSEMBLY
TAKE UP SPRING
1
E
C
D
DETAIL 2
B
DETAIL 1
Figure 11
Figure 12
Note: See “HQ Quilting Machines Getting Started”
DVD (included with your machine) for videos show-
ing threading and other tips. These videos are also
available on www.HandiQuilter.com.
B
E
C
D
DETAIL 2
F
Figure 12
2� Continue to the three-hole thread guide B.
Beginning at the top of the guide, wrap all three
holes from back to front, handwheel side to needle
side being careful not to cross threads (see Figure
12).