Baby Lock Enlighten BLE3ATW-2, Инструкция и справочник

Страница: 12 / 56

Your Baby Lock Enlighten is equipped with an exclusive "Electrionic Extraordin Air Threading System" for
fast, easy threading of the upper and lower loopers.
One touch of the "Push to Thread" button will automatically thread the loopers. It is no longer necessary to
use tweezers for threading the thread guides. If a looper thread breaks or runs out, just re-thread it. There
is no need to follow a specific threading sequence.
1. Open the front cover.
2. Raise the presser foot to release all threads.
3. Set the threading lever from serging position to threading position (fig.A).
4. Rotate the machine handwheel slowly toward you until the tubes move to connectiong position (fig.B).
Note: The Enlighten must be in the locked position when threading the loopers unless otherwise indicated .
1. With the presser foot up and threding lever in the threading position ( fig. A) .
2. Place the thread cone or spool on the far right front spool pin on the thread stand (fig.C page 11).
Slip the thread into the telescopic antenna thread guide "1" directly above the spool, snap into the thread
guide "2" at the top of the machine, through the slot on the front of the machine (fig. C page 11).
3. Pull 18 inches (45cm) of thread through guide "3". Insert the end of the thread into the threading port "L"
about 1/2 inch (1.2cm) . Use tweezers if necessary, to insert the thread end more easily.
4. Push the threading button (fig. D page 11) . If the thread does not go through the lower looper eye with
one push, push the threading button again until it does. *(page 11)
5. Clip the thread 4 inches (10cm) from the lower looper eye and leave it hanging loose.
6. Set the threading lever to serging position.
S
E
R
G
E
R
S
E
T
U
P
10
Threading Your Enlighten
Threading Position for Threading
Lower Looper
Threading Lever
A
B