12
Possible Remedy
Temperature of dispensed
formula is too cold.
Water has not yet been heated to correct
temperature.
Wait for heater to warm water in tank. Green LED in
“temp” section of control panel will illuminate
when water reaches correct temperature
.
Powder container is removed or not fully seated.
Powder container lid is not completely closed.
Powder container lid is on backwards.
Turn Powder container lid clockwise to close
completely.
Make sure tab on outer edge of Powder Container
Lid is facing the back of the machine and engaged
with safety switch. See page 6, Step 7 for details.
Water in Water Tank is too cold.
( Green & Yellow Temp LED’s Flashing)
Water in Water Tank is too hot.
( Green & Yellow Temp LED’s Flashing)
Dump out and refill with room temperature water.
Insert funnel or push front of funnel until flush
with machine.
Place water tank on base or push down all the way.
Add more room temperature water to water tank.
Place powder container on base or push down
all the way.
Make sure the plug is securely inserted into the
power outlet.
Turn switch on lower back of unit from off to on.
TROUBLESHOOTING
Condition
Possible Cause
Machine will not start.
Unit is unplugged.
Unit is not turned on.
Funnel is removed or not fully inserted.
Water Tank is removed or not fully seated.
Water level is below “MIN” line.
Dump out and refill with room temperature water.
11
TOUCH DISPLAY CONTROLS
TEMPERATURE INDICATOR LIGHTS
Flashing Yellow means:
water is heating.
Solid Green means:
water is warm & ready.
Flashing Yellow & Green means:
water poured into tank is too hot
or too cold.
No Water Warning LED
Water Temperature Indicator LED’s
Water volume Selector Button
Water volume Indicator LED’s
Start Button
Stop Button
Funnel Warning LED
SETUP CHECKLIST
Your Formula Pro® is set up correctly when you have:
Washed and thoroughly dried all removable parts according to the cleaning instructions. (no dishwasher, sterilizing, or boiling water.)
Assembled the Formula Pro® correctly.
Flushed the Formula Pro® with water. (use only room temperature water)
Funnel Cover is not straight on funnel or
not pushed down completely.
Align tab on front of Funnel Cover with notch in
Funnel and push down Funnel Cover completely.
Funnel will not fit all the way
in Funnel Compartment.
Funnel LED flashing,
Formula Pro beeps when
start button is pressed.
Funnel and hole on underside of
Powder Container require cleaning.
Follow Steps on Page 9 to clean and dry Funnel and
hole on underside of Powder Container.