♦
Connecting to power supply
Make sure you always connect the machine up to an earthed mains
socket.
Extension cables should be carefully chosen, assembled and
maintained. Your safety will obviously be protected if the insulation
is in good condition. Cables should be inspected on a regular basis
and replaced, rather than repaired, if found to be faulty. Adapt any
electrical extension lengths and sections depending on the work at
hand.
BE CAREFUL:
make sure that the voltage indicated on the identification plate corresponds
to that of the local grid.
Powering-up
Plug the power cable into a properly earthed mains socket.
Switch the machine on using the On/Off switch and a welcome message will
appear on the display screen. If this is not the case, please refer to the
section "TROUBLESHOOTING".
Changing voltage or fuses
For this job you will need to remove the rack
from the machine.
Turn off the machine.
Remove the power cable from the mains.
Unplug the right-angle plug on the power
cable from the machine.
Loosen the 2 fixing screws (
1
) by two turns,
using the size-4 Allen key.
Remove the rack from the machine by
pulling on the lower handle (
2
).
I
0
1
11
2
