7.1.2.3 Carry out a thorough cleaning of the en�re pla�orms with broom, vacuum or
pressure washer
.
(Do not use high pressure cleaners.)
Recommended frequency: A�er the winter season ends, otherwise in addi�on to basic cleaning
7.1.3
Basic cleaning of the machine body/ground/pit, parts in the pit
7.1.3.1 Wet clean the ground/pits:
Remove snow, rain, surface water etc. on the ground/in the pits by cleaning e.g. vacuum and then properly
dispose of. It is necessary to secure the parking li� from lowering.
Recommended frequency: At least 1 x yearly, in winter monthly 1 x addi�onally check and if required carry out
7.1.3.2 Posts, post bases and post mounts are to be cleaned of dirt deposits.
Recommended frequency: At least 2 x yearly
7.1.3.3 Dry clean the pits, swept-clean.
Cau�on: Risk to life and limb! Before cleaning the ground/pits it is essen�al to request your local
Babcopark
partner to secure the parking li�s.
7.1.4
Disposal
For the proper disposal the local authori�es, such as municipal authori�es, environmental protec�on office or
trade supervisory council, are to be informed – insofar as residual substances from car oils, ba�eries or similar have
been collected.
Recommended frequency: As required
7.2
Surface maintenance
The parts have undergone different corrosion protec�on measures, depending on their atmospheric or mechanical
loading as well as the individual requirements called for by the client. For an effec�ve, long-term protec�on the
following care requirements are to be observed:
7.2.1
Galvanized waving plates surfaces
7.2.1.1 Zinc oxide (white haze) is caused by
moisture
, poor ven�la�on or similar. We recommend the use of
grinding wool grain A 280 medium fine or a brass brush (do not use wire brush!).
Cau�on: do not use grinding paper or grinding cloth, risk of damaging the surface. If required coat a�erwards
with a resistant coa�ng material.
Recommended frequency: If required for op�cal reasons
7.2.1.2 Iron oxide (rust) caused, for example, by mechanical loading, wear, road salt deposits, insufficient or
neglected care. Care measures by means of lightly rubbing down the damaged surface with grinding wool
grain A 280 medium fine. Paint treated surfaces.
Recommended frequency: At least 1 x yearly. Check during basic cleaning, and treat if need be
7.2.2
Screws, nuts, washers
When performing basic cleaning of the units immediately check all screws, nuts and washers for correct fit. In the
event of rust, brush with a brass brush applying light pressure and clean and spray protec�ve wax a�er cleaning.
Recommended frequency: At least 4 x yearly. Check and treat if necessary
7.2.3
Powder coated surfaces
Damage due to mechanical or other effects are to be treated as soon as they are detected in order to prevent
impairments or infiltra�on of the powder coa�ng. Care or improvement measures are to be carried out as follows:
light rubbing with emery cloth, grain 120 or brass brush (do not use a wire brush!) followed by cleaning and
degreasing with brake cleaner. Apply the touch-up paint to the damaged points with a brush, such as, for example
Touch-up paint RAL 7016 anthracite grey, air-dried.
47
Surface Cleaning & Maintenance
Содержание Starke 2121
Страница 1: ...User Manual for Pit Lift ...
