1
©2020 Babcock-Davis, Inc.
Rev 8/2020
Installation, Operation
+ Maintenance Manual
Safe-T-Lume™ MARKING STRIP
Model(s): BEM-DS1
GENERAL DESCRIPTION
Photoluminescent egress path marking systems are an
important life safety requirement in current building
codes. These systems allow for the safe and quick
evacuation of buildings in the case of an emergency.
They provide a routing system that is not dependent
on electrical power that can easily be followed in dark
and smoke-filled exit pathways.
Introd Safety
Please read the complete instructions carefully before beginning any work. To ensure proper
installation and performance of the product, the following actions must be completed by the
installing contractor. Failure to do so will affect product warranty.
Transpor Storage
o
Inspect all shipments and materials for missing or damaged components and hardware.
o
Material must be stored in a clean, dry location.
Preparation
Please read the complete instructions carefully before beginning any work.
o
The temperature of the product being installed and the surface it is being installed on must be at
least 60 degrees.
o
Surfaces must be clean, smooth, and non-porous. Install a sample piece of the strip material for 24
hours on the application surface to ensure that the strip adheres properly before doing a complete
project installation.
o
Gloves should be used when handling and installing the strip to prevent injury.
GENERAL SAFETY PRECAUTIONS
Improper selection, installation, or use can cause personal injury or property damage. It
is solely the responsibility of the user, through its own analysis to select products suitable for their specific application
requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,
state and federal regulations for proper installation and operation requirements.
