© Baader Planetarium GmbH | 2020
15
5. Attach the TQC Quickchanger with star diagonal and T-2 nosepiece at the
binoviewer.
6. Attach the binoviewer to your telescope and make sure that the connection is
sturdy.
7. Remove the dust covers from the eyepiece
clamps by opening the ClickLock
®
-clamps. Sim-
ply rotate them to open the clamps.
Please note:
Both clamps work in
opposite
directions!
8. Insert two eyepieces with the same design and
focal length into the binoviewer. Clamp them by
turning the Clicklock
®
clamps.
Option 2: Assembly without Star Diagonal
You can connect the ring dovetail of binoviewer
directly to a nosepiece, too, if you don't want to use a
star diagonal. Because of the necessary quickchang-
er, the optical length increases a little bit. Nevertheless, this may be useful e.g. if you
want to use the binoviewer with several telescopes.
The two glasspath correctors with factor 1,25x and 1,7x can be screwed into the
ring dovetail, as described for option 1. Then, you can use the TQC quickchanger
# 2456313A
to connect the binoviewer to every T-2-thread, either directly at the tel-
escope or to a nosepiece.
The 2,6x glasspath corrector must be inserted into the 2" nosepiece
# 2408150
. For
this, you need the plastic spacer ring which is included with glasspath corrector (im-
age below). Insert the GC into the nosepiece and screw the TQC quickchanger onto
the nosepiece. Now you can use the MaxBright II with every 2" focuser.
The glasspath corrector can be screwed
into the 1,25" nosepiece.
Once the glasspath corrector is centered
in the 2"/T-2 nosepiece, it can be screwed
onto the quickchanger, which fits onto the
ring dovetail of the binoviewer.
This image shows how to insert a glas-
spath corrector into the optional T-2/2"
adapter. The black spacer ring fits onto
the thread of the glasspath corrector and
centres it in the nosepiece.
