b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
[email protected] · www.b4adventure.com 303-339-0482 - DC:080818
6
STEP 2:
U-Clamp installation - Have your helping friends use their brooms to lift and support the trolley and
cable while you perform the installation. This will help you pull out the slack and attach your U-Clamps.
when you wrap your zipline around the Finish Point tree, you want to form a “tear drop” shape wrapped
around the tree - see Figure 3 on next page. DO NOT TIGHTEN UP AGAINST THE TREE!
• With two helpers supporting the trolley and cable, pull the wrapped cable as tight as you can with your
hands. While holding tight with one hand attach the first U-Clamp and tighten slightly (2 Ft. from tree)
• Repeat the above until you removed as much slack by hand as possible. Then tighten the first U-Clamp to
30 Lbs of torque, or as snug as you can with hand tools. DO NOT OVER-TIGHTEN.
• Tidy up your excess cable by simply coiling it up and securing and covering the coil with duct tape.
Starting Point
Finish Point
Trolley
Clamps
Three small
supporting
nails
Three small
supporting
nails
See instructions for proper mounting heights. Do not suspend cable
over any hard surface. Stable mounting platform required for safe and
proper use. Tools needed: Pliers & wrench.
WARNING! CHOKING HAZARD
This product contains small parts. Do not
allow children under 3 years of age near
the parts or assembly area.