b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
[email protected] · www.b4adventure.com 303-339-0482 - DC:080818
2
1. CONSTRUCTING THE HOOP
• The hoop is comprised of 8 pieces that snap together to form 1 ring.
• Start by holding up 2 pieces at opposite ends. Each piece should have an opening with a notch, and
an elongated piece that fits into the open end. Be sure that the notch is lined up with the appropriate
slot on the elongated piece (Figure 1).
• Insert the end with the elongated piece into the open end of the opposite piece (Figure 2). Then,
twist the notch end counter-clockwise to lock in place (Figure 3).
• Continue this process with each piece until the hoop is completed.
2. ATTACHING THE WATER SPRAYER
• Attach the water sprayer to the hoop by using the included clips (Figures 4 & 5).
• NOTE: Attach your water sprayer BEFORE installing the hoop on the poles.
3. CONNECTING THE HOOP TO THE POLES
• Snap the 2 pole segments together using the attachment pieces and insert the poles into each base
(Figure 6 & 7).
• Using the 2 provided clips, snap them onto each side of the hoop parallel to each other (Figure 8).
• Slide the other end of the clip onto the pole on each side (Figure 9).
Figure 1
Figure 2
Figure 3
Figure 6
Figure 7
Figure 8
Figure 9
Figure 5
Figure 4
