IR-B02 Page 3
equipment and facility engineering
Any person should keep away from the painting place for at least 4 meters.
This device should not be directed at staff or highly flammable substances.
Do not move the machine during operations. It can lead to premature failure of the emitter.
Keep your body away from the floor to reduce the possibility of electric shock.
In order to avoid overheating, do not cover the heater. The instructions shall state that the
heater must not be located immediately below a socket-outlet. The instructions for stationary
visibly glowing radiant heaters shall warn about the possible danger of installation close to
curtains and other combustible materials.
When the machine is working, try your best not to allow any stander-by, child or visitor close to
the site. If necessary, protective equipment should be provided.
It is not allowed to use two lamps to bake or allow one lamp to bake the other one when there is
no object to be baked.
Don’t misuse the electric wire. It is not allowed to drag the machine with the power wire or pull
the power plug. Please keep the power wire away from the hot, oily or sharp or movable
objects. Please replace the damaged cables and wires as soon as possible for avoidance of
electric shock.
2.3 Maintenance and care
Regular cleaning of tubes and reflector panel should be done by using a piece of soft cloth or
cotton with alcohol (Note: cleaning must be conducted after the machine is disconnected with
the power and cooled down). You are not allowed to start the lamp tube until the alcohol
becomes volatile, otherwise it may lead to explosion.
The device has to be protected by a 11-Ampere-fuse.
The machine should be well grounded for safety. The grounding device should be connected to
the proper output port under correct direction. Unauthorized alteration or change of output
port is strictly prohibited. Use of any outlet converter is also disallowed. For any uncertainty,
please find a professional electrician to check whether the grounding is correct. Please make
sure the machine is well grounded to avoid the electric shock.
If the wire is damaged, contact the manufacturer, service provider or a professional to replace it
in order to avoid injuries and accidents. Please replace damaged wires and power lines as soon
as possible to avoid electric shocks.
For replacement of lamp tube, ask the repair service center or a technician to do so.
2.4 More information
If any lamp tube fails to work after starting, it may result from the loosened outlet socket. In such
case, just switch off the machine and lock the socket on the arm box.
