8
Leave a clearance of at least 200mm between the appliance and any combustible surface.
No combustible materials shall be located within 500mm of the wok table.
Gas Connection
The gas connection is male 3/4” BSP and is situated at the rear of the a
ppliance below the main body frame. The
number of gas inlets corresponds to the number of wok support rings the appliance is fitted with. The inlet is to the
¾” elbow located at the rear of the appliance.
This appliance is available in models for fixed installation or in models fitted with lockable wheels/castors.
The appliance can be connected with rigid pipe as specified in AS/NZS5601. For fixed installation models we
recommend connection with 20mm copper tube and an Australian certified isolating valve.
For models fitted with lockable wheels/castors an Australian certified stainless steel braided flexible hose of adequate
internal diameter must be used. The fitting of the hose must comply with the relevant sections of gas installation code
AS/NZS 5601. A restraining chain or wire must be fitted. We recommend a maximum length of 1.5 m for the flexible
hose. When the appliance is in position all of the wheels/castors must have the built in lock on to prevent any
movement of the appliance. An Australian certified isolating ball valve must also be fitted.
BEFORE CONNECTING NEW PIPE TO THIS APPLIANCE, THE PIPE MUST BE BLOWN OUT THOROUGHLY TO REMOVE
ALL FOREIGN MATERIAL. FOREIGN MATERIAL IN THE BURNER AND GAS CONTROLS WILL CAUSE IMPROPER AND
DANGEROUS OPERATION.
Connect to gas.
Pressure Test Point
All appliances that are dispatched from our factory are tested and adjusted according to the specifications for the
required gas type. The regulator may require adjustment to achieve required gas pressure.
Check the burner pressure at the test point on the regulator. The test point pressure should be adjusted to 1.00 kPa
–
Natural gas or 2.60 kPa
– LPG with the burners operating at maximum.
Water Connection
The water connection is 15mm copper and is situated at the rear of the appliance below the main body frame. The
number of water inlets varies to client’s particular needs. Water isolation valves are fitted to all water inlets. Ensure
water is flushed through before final connection.
Appliances installed with lockable wheels or castors should have appropriate flexi hose (according to the Australian
standards) for water connection.
Water waste outlet is located on the left hand side of the waste gutter of the appliance (50mm connection). The water
inlets and water drains should be connected with rigid copper pipes.
We strongly advise against the usage of
plastic/PVC piping for connection of waste outlet.
Before Leaving - Commissioning
Check
all
connections for gas leaks with soap and water.
Do not
use a naked flame for detecting leaks.
Ignite the pilot and main burners as prescribed below to ensure correct operation of gas valves, burners and ignition.
When satisfied with the operation of the appliance, please instruct the user on the correct method of operation.
Ensure that this instruction manual is left with owner of the appliance.
POT BURNER
– WHERE FITTED
If pot burner fitted with pilot and/or flame failure
A.
Ensure gas control is in the ‘OFF’ position.
B.
Depress operating knob of relevant burner and turn anti-
clockwise ‘PILOT’ position and light pilot.
C.
Observe the pilot light is established. Pilot flame should be between 10-20mm in size and be in direct contact
with thermocouple (where fitted). Should the thermocouple require adjustment, lift of trivet and undo the nut
holding thermocouple on pilot assembly. After adjusting reassemble in reverse order.
