B.Pro TS-H1, Перевод оригинальной инструкции по эксплуатации

Страница: 18 / 52

18
Mobile Plate Dispenser OPERATING INSTRUCTIONS
Commissioning
9
Unit has reached room temperature
9
There are no signs of defects or visible damage to the unit
9
The following settings carried out correctly and adapted to the new situation if necessary
9
Any existing protective film is completely removed
)
The insulation material may emit slight fumes or faint odours as it becomes hot on initial start-
up. For this reason, we recommend heating the unit empty for approx. 2 hours before the
initial use.
9
The unit is switched off
Caution!
Damage to the unit's electrical system.
The unit's electrical system may suffer damage if the unit is not designed for the available mains
voltage or frequency.
–
Before connecting, make sure that the mains voltage and mains frequency on the rating plate
correspond with those for the mains socket outlet.
– Ensure that no objects which are sensitive to heat are located inside the unit or on the unit
top.
– Connect the mains plug to the socket outlet.
– Switch on unit with the On/Off switch.
The operation indicator illuminates.
– Set rotary knob to the highest level.
– Heat unit approx. 2 hours.
– Switch off unit with the On/Off switch.
The operation indicator goes out.
– Clean the unit after it cools down.
ª
Chapter "Cleaning and Care"
L The plate dispenser guide rods can be adjusted to the specific diameter of the plates used.
We recommend using the plates to be used to test which setting range is most suitable.
Prerequisites for
operation
Initial start-up
Adjusting guide rods to
the plate diameter