12
2.2.3 Conducting a Test
Test can be conducted any time Ready/Complete LED is ON by
pressing the “Load Test” key.
By doing so the ‘Test On’ LED starts glowing.
Typically, it glows for about 2 seconds. Thereafter the ‘Ready’
test starts blinking.
(The blinking time depends on the Ah range selected).
Thereafter it becomes steady.
Note: User cannot conduct a test while the ‘Ready’ LED is
blinking.
2.2.4 Observing Result After a Test
By default the Battery Voltage is displayed on the display. To observe
the Balance Capacity left, press the ‘Display Mode’ switch.
The display will show the capacity in percentage.
Note: Balance Capacity can have a meaningful value only after
conduction of a test. At power on, a value of 0 is shown. Hence
Balance Capacity should be seen only after conduction of a test. To
observe No Load Battery Voltage, press the ‘Display Mode Key’. The
display will show the No Load Battery Voltage.
1) Do not connect Model 600B to a voltage source more than 20V.
2) Do not connect the unit to a battery connected in circuit.
www.
.com
1.800.561.8187
