B-K Medical Pro Focus 2202, Руководство пользователя

Страница: 302 / 356

302 Chapter 20
To slice the volume:
1 Move the cursor onto one of the volume faces.
The cursor looks like this:
2 Hold the
[
A
]
key down while you drag the cursor to move the plane through
the volume until the cut face you want is visible.
3 To restore parts of the volume that you have sliced away, drag the cut plane back
through the volume.
Tilting a Plane
You can tilt a plane to see views that are not parallel to one of the original faces of
the volume. (This often creates additional planes.)
To tilt a plane:
1 Click the edge of a plane to select it.
The cursor looks like this , and the wire frame around the plane becomes
red.
2 Hold the
[
A
]
key down while you drag the cursor to tilt the cut plane.
You can then move the tilted cut plane in and out (slice) as described before.
Moving the Volume
To move the volume:
1
Move the cursor so that it is inside the volume.
2 Hold down the Shift key (on the keyboard) and the
[
A
]
key on the control
panel.
The cursor looks like a hand.
3
Drag the volume to the position you want, while holding
Shift
and
[
A
]
down.
4 Click when the volume is where you want it.
Animating the Volume
To make the volume rotate automatically forward and back:
• Click Play under Animate.
The volume rotates continuously.
To stop the rotation, click Animate again.
Under Animate on the right side of the screen, you can click to adjust the following
animation parameters:
• Direction – Horizontal or Vertical
• Speed
• Span – the extent of the rotation