RELEASE DATE
12-6-16
REFERENCE
NUMBER
INS-2145-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
3. Remove optic by twisting gently, then pulling
away.
2. Pull accessory holder from clips on accessory
bracket.
Relamping with Accessory Holder
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
TENAYA2® SERIES
Relamping & Accessories
1. Install the faceplate using 3/16” Allen wrench
and torque the faceplate screws in a cross
pattern to 25 in-lbs.
5. Remove optic holder by loosening two (2)
#4-40 screws using a 0.05” Allen wrench.
6. Carefully remove LED module from heatsink.
Do not pull on connector or wiring. Handle
with care.
Fragile! Do not pull on connector or wiring.
Handle with care.
7. Use small pick tool to push connector off
LED board through two small slots behind
connector. Once loose, lift connector upwards
and off board.
8. Place new LED module onto heatsink. Press
connector straight downwards into slot on
module to snap into place.
Connector will only fit in one direction.
4. Loosen (2) #6-32 set screws holding accessory
bracket to OptiLock™ as shown. Remove
accessory holder from OptiLock™.
9. Replace optic holder by tightening two (2)
#4-40 screws using a 0.05” Allen wrench to
secure to OptiLock™.