B-band A3T, Руководство пользователя

Страница: 5 / 22

55
tery is connected.
7. CHROMATIC TUNER
8. TUNER ON / OFF BUTTON
The tuner will work with or without a cable plugged
into the output jack.
Pushing the tuner button (8) turns ON the tuner.
When the tuner is active the pickup system output
is muted. No sound will go to the amplifier or mixer
when the tuner is active.
Pushing the tuner button (8) again turns the tuner
OFF and the pickup system output will be active
and sound will go to the amplifier.
If the tuner is ON and the tuner button is not pushed
within 2 minutes the tuner will turn OFF automati-
cally and sound returned to the output.
The tuner has a seven Note Readout Display; Half-
step (#) LED; Sharp arrow LED; Flat arrow LED and
In-Tune LED.
The tuner Note Readout Display shows the near-
est note of one plucked string’s sound. If the note
showing is a half step (for example A#; C#, D# and
so), the half-step (#) LED will light.
If the Sharp LED is showing the string needs to be
lowered in pitch.
If the Flat LED is showing the string needs to be
raised in pitch.
When the In-Tune LED lights the string is at the cor-
rect pitch of the note displayed at the Note Read-
out Display.
SETTING UP THE PREAMP FOR USE
Tune the guitar. See the tuner instructions at 7 and
8.
Before plugging a cable into the guitar’s output
jack, turn the volume control OFF (“0”), turn the
4-band EQ controls to the middle position center
detent (half way between “-12” and “+12”) and turn
the tuner OFF.
Check that the 9-volt battery is good.
Make sure that the amplifier or mixer volume is OFF
and the EQ tone controls are at flat or off. Plug a
guitar cable into the output jack of the guitar and
into the input of the amplifier or mixer.
Turn the volume control of the A3T half way up (half
way between “0” and “+12”). Turn the volume of
the amplifier or mixer up enough to get a good level
of sound. Refer to the amplifier or mixer instruc-
tions on how to set up best gain structure with an
instrument for the cleanest possible sound.
Once the desired volume level is found use the EQ
on the A3T preamp to find your tone.
Try turning the MIDDLE CONTROL down a little to
cut this tone. This will bring some smoothness to
the sound. Turn up the BASS control some to add
fullness to the sound. Use the PRESENCE control
Note readout display
Sharp LED
In-tune LED
Flat LED
Half step LED