INSTRUCTION MANUAL
TagTemp
Temperature Data Logger
Technical changes reserved
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
0141 0315-84 22.06.2016
Fon +49 771 83160 | Fax +49 771 831650 | [email protected] | bb-sensors.com
5 / 14
6.
PRODUCT DESCRIPTION
TagTemp
is a small portable electronic temperature data logger. Its internal sensor measures local environment temperature and
logs the values in an electronic memory. Logged data, or ACQUISITIONS, can be later viewed and analyzed on a PC where they
can be opened in tabular and graph forms.
The configuration and data transfer can be fulfilled
only
with the IrLink communication wand which is supplied with
Logchart-II
software.
The software enables to set up the logger operation mode. It is also used for viewing acquisitions. Other parameters such as end of
measurements, logging interval, etc., are easily defined through the
LogChart-II
software.
Acquisitions can also be exported to be analyzed in other applications, such as spreadsheet programs.
1.1.
Supply voltage
The Temperature Data logger TagTemp is a highly autonome temperature measurement device. It is supplied with a built-in 3.6 V
lithium battery (CR2032).
6.2.
Unpacking
The following items must be included in the package:
The electronic logger TagTemp;
A CD-ROM with the Logchart-II software and a USB driver;
Quick logger operation guide.
The present operating instructions
Optional : a communication interface (upon request)
6.3.
Identification
The identification label is on the logger body. Check if the features described are in accordance with your order.
The following elements are shown in the logger front.
Start/stop button (S)
This button “wakes up” the logger whenever a communication between
logger and PC is intended to start. It can also be configured to start or
stop the temperature measurement process.
IR
communication
Window
PC - Logger communication area. During download, the communication
interface must be directed towards this window.
Status indicator (LOG)
While in stand-by (not logging) or after a series of measurements, it
flashes once, during logging twice at every four seconds.
Alarm Indicator (AL)
Warns the user as to alarm conditions. Whenever an alarm situation
takes place it will flash once at every four seconds, until a new
configuration is applied to the logger.