The
AZZA
U601 Mainboard Series
Page 14
PGA 370
Lock
Free
PGA 370
Lock
Free
PGA 370
Lock
Free
Alignment Notch
2.4.1. Installation of the CPU
To install your processor, please complete the following set of instructions
1. Locate a small dot marked on the top of the CPU. This mark indicates
Pin 1 of the CPU.
2. Locate Pin 1 (
Alignment Notch
) the Socket on the mainboard.
3.
There is a lever on the side of the socket. First push this lever side-
ways and then lift it to a 90-degree angle.
4.
Insert the CPU into the Socket. Please make sure that Pin 1 for the
CPU is inserted into Pin 1 of the Socket.
5. When the CPU is installed correctly push the lever back into place.
6.
Install a proper heat sink with cooling fan
for proper heat dissi-
pation. Failing to install a heat sink with cooling fan may cause over-
heating which will burnout your CPU and damage your mainboard.
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan.
Without a proper heat sink with cooling fan you will damage both the
mainboard and the CPU.
2.4.2. Memory Modules
The
U601
mainboards have two 168-pin DIMM slots and are able to support a
maximum of 1GB PC-100/PC-133 SDR SDRAM. The DIMM slots are located on
the right hand side of the board. To install the DIMM’s into these slots, make
sure the white lever at each side of the slot has been pulled down to an angle
of approximately 45°. Make sure that the DIMM is in the correct orientation.
Place the DIMM on the slot and push down firmly.The white levers will come
back up and lock the module in place (diagram on next page).
Important: The DIMM’s can only be fitted into the slots in one orien-
tation. Make sure that the DIMM’s are in the correct orientation and
the pins are correctly aligned before you insert them.
2.4. CPU, Memory and Expansion Slots
CPU Socket 370
Supports
Pentium
TM
III (0.18
μ
/0.13
μ
)
Celeron
TM
(0.18
μ
/0.13
μ
)
Hardware Installation
