The KM266-MVB Mainboard
Page 19
Mode 1: Press and hold the Power ON button for less than 4 seconds and then
release it. The system will be turned into Suspend mode (turned into the
GREEN mode) When the system is in the Suspend mode:
!"
"
Press the Power on button (less than 4 seconds), the system will return
to Full-ON mode.
!"
"
Press and hold the Power On Button for more than 4 seconds, the sys-
tem will be powered off.
Mode 2: Press and hold the Power ON button for more than 4 seconds, the
system will be completely powered off.
Option 2: If you choose “Instant OFF.” In the BIOS CMOS Setup, the power
switch will operate like a normal ON / OFF Power button.
2.6.2. HL: IDE HDD LED Connector
Any read and write activity by the HDD will turn this LED on.
2.6.3. RS: Reset Button Connector
If you connect this connector, you will be able to reset you computer by press-
ing the reset button at the front of the chassis.
Hardware Installation
3"#, 2 !
2.7.1. Speaker Connector
(SPK)
Connect your chassis speaker to
this four-pin connector. It allows
you to hear systems beeps and
warnings sound.
2.7.2. Front Panel Power LED
(PWRLED)
The chassis power LED connector
can be connected to the four-pin
connector. When you turn your
system on, this LED will also be
turned on.
PIN 1
SP
K
+5V DC
Speaker Signal
Ground
NC
PWR
LED
Top View of the Power LED
and Speaker Connectors
+5V DC
Speaker Signal
Speaker Signal
NC
PIN 1
