Ultra 440BX ATX Mainboard
AWARD BIOS SETUP
4-14
Suspend Mode
: ( Default setting: Disable )
When enabled and after the set time of system inactivity, all devices except the
CPU will be shut off.
HDD Power Down
: ( Default setting: Disable )
When enabled and after the set time of system inactivity, the hard disk drive will
be powered down while all other devices remain active.
Thorttle Duty Cycle
: (Default setting: 62.5% )
When there is the Winbond W83783S (U2) installed on the board, the CPU speed will
be slowed down (“Throttling Speed”) when the W83783S detects over heating on the
CPU. Slowing down the CPU speed will be the best way to cool down the CPU
temperature and it will protect the CPU from damaged. Use this option to select the
“Throttling Speed” to protect your CPU when over heating.
PCI/VGA Act - Monitor:
(Default setting: Enabled )
When CPU enters the Green mode, the system will keep scanning the status of the
monitor. You may use this field to select whether you are going to have the
monitor get into Green mode or not:
Enable
: The screen display will not be off ( or powered off ) when there is the video
signal sending from VGA card to monitor.
Disable
: The screen display will be blank off ( or powered off ) no matter whether
there is the video signal sending from VGA card to monitor or not.
Soft-Off by PWR-BTTN : (
Default setting: “Instant-off.”)
This field allows user to define the feature of the “PW” connector (it is used to
connect the power button ). The setting can be either “Delay 4 Sec.” or “Instant-
Off”. Please refer to page 3-12 for details of function description.
PowerOn by Ring / LAN :
( Default setting: “Disabled”.)
When “Enabled”, you can resume the system from Sleep or Suspend mode by using
a MODEM Ring-in or a LAN signal. In order to make this feature works normally,
there are some requirement need to be noticed, please see Section 2 for details.
Resume by Alarm :
( Default setting : “Disabled” )
When “Enabled”, the following two selection fields - “Date (of Month) Alarm” and
“Time (hh:mm:ss) Alarm” will appear on the screen. You can use these two fields to
set the date and time which you want to resume the system from Sleep or Suspend
mode. The “Time” must be set in a 24-hour format. (for more detail information,
please refer to Section 2).
