Ultra 440BX ATX Mainboard
AWARD BIOS SETUP
4-10
Note:
1. The higher FSB frequency will surely give you the higher
system performance. However, it is not recommended because
it may cause the system unstable, especially the component like
DRAM, HDD, Add on card is not fast enough.
2. Wrong selection of FSB clock may cause the PC system hang
up and the system can not boot, In case that it should be
happened, use JP9 to clear the CMOS and reset the setting.
The following events appears only when the hardware monitoring is installed
****************************************************************
CPU Warning Temperature : (
Valid when W83783S is installed
on 29
)
The hardware monitoring device – Winbond W83783S
is optional on the
mainboard. When they are installed on the mainboard, you may use this field ( and
the fields below ) to monitor the healthy status of your PC system.
These selection
fields can not be seen unless you have the W83783S installed on the board and
you have enable the “Throttle Duty Cycle” in the “Power Management Setup”
(see section 4.7 )
There is a CD comes with the mainboard. You will find the hardware monitoring
program in the CD. When you have the hardware monitoring software installed in
your PC system, it will let you have a bodyguard in your PC system and it will
keep monitoring the CPU temperature, Cooling fan speed, system voltage … etc.
Whenever it detects the abnormal condition occurs, it will give you the warning
message or slow down the CPU to avoid serious damage to the PC system.
Current CPU1 Temperature: (
Valid when W83783S is installed
on U2)
You can use this field to monitor the CPU temperature.
Current CPUFAN# Speed: (
Valid when W83783S is installed
on U2)
You can use this field to monitor the rotating speed of the CPU cooling fans.
Shutdown Temperature: (
Valid when W83783S is installed
)
The PC system will be shutdown when reach to the given temperature defined in
this field so that the CPU can be protected from damage.
