AzureWave AW-NM230NF-H, Руководство пользователя

Страница: 5 / 25

- 5 -
port of the AP
3. Verify that communication exists between the reference computer and the AW-NM230NF-H demo board by pinging
192.168.1.100
from the AW-NM230NF-H host console.
4. Set up Chariot.
a. On the host computer, activate EndPoint:
b. Using Chariot Console on the reference computer, create two pair groups (192.168.1.100 and 192.168.1.110) using
the Chariot Throughput.scr script. Run the throughput test for a specified period of time and observe the results.
RF Tx/Rx Performance Test
CREATING A Tx TEST
(In Ubuntu linux 12.04)
1. Open the Terminal, enter the command: sudo su and password .
2. Enter
Insmod /(path of dhd.ko file)
firmware_path=/(path of firmware file) nvram_path=/(path of nvram file) to enable.
3. Enter the wl ver command to check the current WL driver version.
4 . Run the following command set (delay at least 700ms between each command) :
11b rate:
./wl mpc 0
./wl country ALL
./wl up
./wl scansuppress 1
./wl band b
./wl channel 7
./wl nrate -r 11
./wl txpwr1 -o -q 68
./wl phy_forcecal 1
./wl pkteng_start 00:11:22:33:44:55 tx 300 1500 0
This will send continuous Tx Packets with 300 us packet interval,1500 byte packet length. Data rate
=11Mbps ,Channel=7 and output power =17dBm(68/4=17 q means quarter).