AzureWave AW-NM230NF-H, Руководство пользователя

Страница: 14 / 25

- 14 -
RF Performance Test
The following procedure explains how to configure the AW-NM230NF-H for RF testing using Broadcom BlueTool. At
the completion of the procedure, connect the Bluetooth test instrument to the AW-NM230NF-H with RF cable and
performs the RF tests.
RESETTING THE USB DEVICE
To reset the USB device
• In HCI Control , in the HCI Control commands list, select 7.3: Host Controller & Baseband Commands (3 key) , and
then double-click Reset .
READING THE BLUETOOTH DEVICE ADDRESS
To read the Bluetooth Device Address
• In HCI Control, in the HCI Control commands list, select 7.4: Informational Parameters (4 key) , and then double-click
Read_BD_ADDR .
The Bluetooth Device Address (BD_ADDR) is displayed in the log window. The Bluetooth Device Address might be
needed
by the Bluetooth tester
SETTING THE EVENT FILTER TO AUTOMATICALLY ALLOW CONNECTION
To set the event filter to automatically allow connection
1. In HCI Control, in the HCI Control commands list, select 7.3: Host Controller & Baseband Commands (3 key) , and
then double-click Set_Event_Filter .
2. In HCI Command: Set_Event_Filter:
a. In the Filter_Type list, select Connection Setup.
b. In the Connection_Setup_Filter_Condition_Type list, select Allow Connections from all devices .
c. In the Auto_Accept_Flag list, select Do Auto accept the connection with role switch disabled .
ENABLING WRITE SCAN
To enable Write Scan
1. In HCI Control, in the HCI Control commands list, select 7.3: Host Controller & Baseband Commands (3 key) , and
then double-click Write_Scan_Enable .
2. In HCI Command: Write_Scan_Enable, in the Scan_Enable list, select Inquiry and Page Scan enabled .
ENABLING TEST MODE