21
AZTECH
WIPC408HD IP CAMERA USER MANUAL v2.0
Figure 20
The wireless setting page is showed as below Figure 20, user can click the “Search” button,
and it will show you the WIFI network it has detected. Please select one, and the network
data will fill in the blanks automatically. (For example, SSID, encryption algorithm etc.). User
only needs to fill in the password and retype the password. After you configured it, you
can click the “Check” button to check if there is any mistake. After verification, please click
“Apply” button to set it.
Note: before you set up wireless parameters, make sure the device is
connected to the Internet. After setting successfully, reboot the device and the
wireless function takes effect. On rebooting the device, it will take about 30
seconds before the camera will auto pan and tilt by itself. Then, Wait for two (2)
minutes for the camera to establish wireless connection to the router.
7.2.3 Remote Access Setting
1
）
Manufacturer’s DDNS and Third Part Dynamic DNS: Please refer to the content of the
part 6.2.
2
）
UPNP:
UPNP stands for universal plug and play, if you started UPNP, once the IP
camera was connected into the LAN, it will communicate with the router of the LAN. It will
request the router to open a port to forward its own port.
Before using UPNP function, please make sure the router’s UPNP function has
been triggered. Because there are so many different routers, and not all of them
can support UPNP. Please test if the router work well with the equipment, if not, we
would suggest to set Port Forwarding Function on your router.
3
）
WAN IP Test: Click the “Show” button, it will show you another page displaying the WAN
IP address when it is connected to the Internet.
7.3 Alarm Setting Page
7.3.1 External Alarm Input
Figure 21
Figure 22 below has listed the external alarm input setting. If the alarm input pins have been
connected with an alarm detector (Figure 4), please tick the “External Alarm”, and then you
will have enabled external alarm function. If the external alarm detector is open mode, please
tick “Open”, vice versa.
