V300ATA VoIP User Manual
- 18 -
6.2 LAN & DHCP Configuration
This page let you configure your Local Area Network and DHCP server.
Figure 6-2 LAN & DHCP Configuration
To setup the LAN and DHCP settings, please do the following:
1.
LAN Setting (Router Configuration)
: This is where you assign a local IP address to
your router. The factory default value is 10.0.0.99 with a subnet mask of
255.255.255.0.
(Note: When you change the LAN Setting of the Router, you need to reset/renew the
Local computer IP address.)
2.
Enable DHCP Server
: Tick to enable DHCP (Dynamic Host Configuration
Protocol). When enabled, router will provide IP address to the computers connected
to the router.
3.
DHCP address pool selection, System Allocated
: If this is selected, router will
assigns IP address automatically from 10.0.0.4 to 10.0.0.15.
4.
DHCP address pool selection, User Defined:
If this is selected, router will assigns
IP address automatically from the DHCP address pool (For User Defined only). User
can set up to 253 IP addresses in the address pool.
