NEVER CHANGE OR ALTER THE PROPANE
CONTROL EQUIPMENT.
SAFETY
Provide and use ear protection during operation.
NEVER TILT THIS MACHINE ON ITS SIDE.
Never let an untrained person operate or
perform repairs on the machine. They may hurt
themselves, damage the floor or the equipment.
Engine speed not to exceed 3400 RPM.
DO NOT use machine with a damaged or
disintigrated pad to avoid excess vibration.
Do not use on surfaces with a gradient
exceeding 2%.
OPERATING PROCEDURES
A. Adjusting the Handle Height
The UltraGrind is equipped with a telescoping and
adjustable handle.
UltraGrind Transport Handle Position
Diamond Change Handle Position
Operating Handle Position
B. Plate Assembly and Diamond Installation
Resin Bond
Metal Bond with 3 Screws
Metal Bond
with 1 Screw
Resin Bond
1. Close service valve on fuel cylinder to
prevent liquid from getting into the
regulator.
2. Tilt machine back to access the drive pad
3. Align diamond shoe with slots in drive pad
and push firmly into slot.
4. Examine red flex plate disc for signs of wear;
see daily maintenance requirements.
C. Transport Wheel
Remove transport wheel before operating machine
1. Extend handle to fully extended position.
2. Press downward on the handle bar until it
3. Release locking pin on transport wheel
bracket & remove transport wheel.
rests on the ground.
1st Hole
Handle pinned
in 2nd hole
Wheel bracket
Handle fully
extended
Close up of handle
in pivot bracket
Handle pinned
in 1st hole
Close up of handle
in pivot bracket
Locking pin
PG. 6 ULTRAGRIND
