AB-6584
11
Precautions for Use
•
Do not mount the product under the conditions of high temperature and humidity.
•
Be sure not to drop the product.
•
Be sure to shut down the power (disconnect the wiring between the power supply and the product power terminals) for the
wire replacement.
•
Before turning on the power, make sure that wires are correctly connected.
•
Do not connect wires to vacant terminals.
•
Several tens of seconds are required for the product normal operation after the power is turned on. During this time, the
LED on the front lights up temporarily, but this does not indicate an error.
•
Be sure to use a small-power circuit to turn on/off the fan.
•
Be sure to use a shielded wire for the signals output to the inverter.
•
Leave at least 35 mm clearance between the top/bottom surfaces of the product and other devices.
•
Peel off the protective sheet on the top surface of the product before turning on the power (see Fig. 8).
Figure 8. Battery label and protective sheet
Protective sheet
Battery label
on the indication tag
注
意
この
保護
シー
トは
ケー
ブル
の配
線
被絶
完了
後、
必ず
取り
外して
下さ
い。
Discard these
dust protection
sheets after the
completion of the
wiring