AB-6655
15
2) Fully close the actuator of this product, and mount it to the damper shaft. Finger-tighten the fastening nuts of the shaft
clamp to temporarily fix the actuator.
Figure 12. Temporal installation of the actuator body
3) While pressing the gear release button, manually rotate the shaft clamp until it is in the upright position. Then, insert the
universal bracket (protruding part) into the slit of this product and fix the bracket with the two M4 tapping screws.
Note:
The universal bracket, required for the installation of this product, is commercially available. The universal bracket is also available at
Azbil Corporation (Universal bracket: Part No. 12595-00001). Be sure to separately order if necessary.
Figure 13. Attaching the universal bracket
1. Mount.
2. Finger-tighten.
Fastening nuts
Shaft clamp
1. Press and hold.
Gear release button
1. Rotate.
2. Insert.
Universal bracket
Slit
M4 tapping screws
Shaft clamp
