Ayrton eurus s, Руководство пользователя, Страница: 18 / 48

17
controller which connected.The fixture can log in the wireless transmitter
，
and receive only
radio signal from transmitter ， but not DMX from the transmitter.
OFF ：（ De-activate WDMX ）
In this status ， wireless system is not activated ， so the fixture can not log in the transmitter.
REST
：（ reset WDMX memory ）
Can remove the fixture from the connection with the transmitter
，
the fixture become free and
ready to log in any transmitter.
9.4 Setup the wireless system ：
1) Connect the transmitter with the DMX controller.
2) To make the fixture installed with wireless receiver log in to the transmitter.
a) Initially ， the indicator on the receiver fixture should be in Solid red.
b) Press and hold the configuration button on transmitter for less than 3 seconds the
red/green LEDs on the transmitter and the receiver fixture will flash rapidly for about
5~ 10 seconds while the system goes through its setup procedure.
c) Once the receiver fixture is logged in to the transmitter （ T1 ）， the fixture with wireless
receiver will keep the memory
，
even if restart the power
，
this unit will log in the
transmitter （ T1 ） automatically.
3) Use the DMX 512 to control the fixture
9.5 Remove the receivers from transmitter （ T1 ） and to log in to another transmitter （ T2 ）：
Case 1 ： Remove a receiver ：
a) On the control board of the fixture
，
enter menu to activated the function of REST
；
b) The LED for wireless on the fixture should turn to Solid red; the receiver can log out from
the transmitter
（ T1 ）；
c) press the configuration button on transmitter
（
T2
）
for less than 3 second
，
then the fixture
will start to connect with the transmitter
（
T2
）
.
Case 2
：
Remove all receivers from a transmitter
（
T1
）
to log in to T2
：
a) Press and hold the configuration button on the T1 as least 5 seconds ， can clear the
connection with all the fixtures
；
b) All the red/green LEDs on the receiver fixtures will turn to Solid red to indicate that the
receivers are unassigned and removed from the transmitter
（
T1
）；
c) Press and hold the configuration button on the T2 less then less than 3 second ， the fixtures
will connect with the T2.
PS ：
1. Please log the receivers out from the transmitter after every job
，
so that the receivers are in
free un assigned state and ready to be assigned to a transmitter.
2.
Do not connect the fixture which is under the communication of wireless system to the
DMX controller ， otherwise it will cause interference from the DMX controller.