ULTRA-QUICKSTART GUIDE
These directions are minimized for more knowledgeable/experienced installers.
For the "regular"
�
uickstart instructions, turn these directions over. For more
detailed instructions, please see https://support/ayrstone.com
GET READY: Write down the MAC address of the IndoorHub and put it someplace safe.
If you haven't already, create an account on AyrMesh.com. Note: if you don't already have
AyrMesh devices, create the account from a computer connected to the same router you'll
connect the IndoorHub to. Otherwise you may need to enter the MAC address manually.
2
ASSEMBLE: Connect the IndoorHub to the power supply with the USB cable.
1
0C:EF:
MAC Addr:
3
INITIALIZE: With an Ethernet cable, connect one of the Ethernet
ports of the IndoorHub to your network (router, Hub, Receiver,
Bridge radio, etc.), then plug in the power supply. Wait until the IndoorHub
checks in to AyrMesh.com - the light will go from blinking rapidly to steady on.
This should take about a minute.
4
INSTALL: Mount the IndoorHub as high and "in the clear" as possible.
You can connect other devices to either of the Ethernet ports on the IndoorAP.