Operation and mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During the start-up process, the step motors in the moving heads will calibrate and position themselves at
absolute zero. The heads may vibrate or make a rattling noise during this process. This is normal and will not
have a negative effect on the lifespan of the product.
During calibration, ‘AYRA’ will be shown on the display, which means the device is not ready to be operated.
Once the device has fully started up, it will jump to the last-used mode. Operation modes and other settings
shown on the display can now be adjusted or changed by means of the menu buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use ‘Up’ and ‘Down’ to change amounts and ‘Menu’ to
go back to the menu. By holding the ‘Menu’ button down for 2 seconds after saving a specific setting, the
device will return to operation mode and adopt the setting. This will also be done after any changes in the
operation mode or DMX address. This operation is not always necessary, considering the device
automatically does this after a new setting is confirmed.
The menu contains the following options and functions
Display
Function
Setting
ADDR / A001
DMX address configuration
Address A001 … A512
CHND
Channel mode selection
6CH/12CH/14CH/27CH
SLND
Slave mode
NAST = Master
SL 1 = Slave 1 – sync mode
SL 2 = Slave 2 – sync & mirrored mode
AUTO
Auto show 0-16 + speed
Auto show AU 0 – AU16
Push up/down for speed, select SP1 - SP9
SHND
Show mode selection (music-
controlled)
Show 0-16
SOUND
Sound-controlled mode
Sound-controlled mode: ON / OFF
SENS
Sensitivity sound-controlled mode
000 – 100: Sensitivity in %
LED
LED display ON / OFF while
device is in use
ON / OFF
DISP
Display invert
Invert display , disp - dslp
PAN
Invert pan movement
YES / NO
TILT
Invert tilt movement
YES / NO
TEST
Test mode
Test mode shows if the buttons and LEDs are
functioning.
HOUR
Time registration
0000 – 9999 hours
VER
Firmware version
Firmware version, not to be upgraded by the
user
RSET
Reset function
Restart the device as if you're re-connecting it to
the power source.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:24-01-2017 RV
Revision date and author's initials: -
