10 mm
10 mm
-26-
3 mm
3 mm
3.Prior using for the first time
normal for a small amount of water to come out of the salt container.
It is
1
2
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the salt warning light may still be on even though the salt container
is filled.
If there is no salt warning light in the control panel (For some Models),you can judge when to load
the salt into
the softener by the cycles that the dishwasher had run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
The salt container is located beneath the basket and should be filled as follows:
A.Remove the basket and then unscrew and remove the cap from the salt container.
B.Before first wash, add 1lt. of water in the salt container of your machine.
C.Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
D.After filling the container , screw the cap tightly back clockwise.
E.Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled
salt.
with
F.Immediately after filling the salt into the salt container, a washing programme should be started (Suggest choose
rapid programme). Otherwise filter system, pump or other important parts of the machine may be damaged by salty
water. It is out of warranty.
1
2
Open
10 mm
10 mm
10 mm
10 mm
Always use the salt intended for use with dishwasher.
Attention!
Only use salt specifically designed for use in dishwashers! All other types of salt not specifically
designed for use in a dishwasher, especially table salt, will damage the water softener. in case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is
liable for any caused damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split,
bottom of the machine for any period of time, which may cause corrosion.
remaining of the
A. Loading the Salt Into the Softener
If your model have
water softener, you may skip this section.
no
NOTE:
10 mm
NOTE:
Содержание ADW06000A
Страница 1: ...13 mm 80 mm 17 mm 42 mm 6 mm 10 mm 6 mm ADW06000A S ...
Страница 12: ... 10 10 mm 3 mm 3 mm 8 1 1 2 3 4 9 5 3 3 6 7 6 10 mm 4 3 1 6 7 8 9 5 2 10 mm 10 mm ...
Страница 48: ......
