Complete * Schaumburg, IL 60173 *
Phone:
888
-
392
-
9947
10
TROUBLE SHOOTING
Defective piston ring (worn or
broken)
Defective inner surface of cylinder
(worn or rough)
Disassemble the output unit and
check the inside and outside
surfaces of the piston ring and
cylinder
Replace the defective parts
Nails clog within
the ejecting gate
Nails are inaccurately fed into the
blade guide
Incorrect nails are loaded
Refer to first item
Refer to first item
Use designated nails
Worn tip of the driver blade
Carry out idle driving and check if
blade tip if worn or not
Replace
Worn guide groove of the blade
guide
Check the wear of the blade guide
Replace
Work piece material is too hard
Stop using the tool
Failure
Possible causes
Check Method
Counter measures
The driven nail is
bent
Nails are inaccurately fed into the
Blade Guide
Incorrect nails are loaded
Refer to item above
Refer to item above
Worn driver blade
Check if the driver blade is
extremely worn or not
Replace the driver blade
The wood is too hard
Check if the nails bend on softer
wood or not
Stop using the tool
The driven nails do
not fully penetrate
the work piece
(heads protrude)
The wood is too hard
-
Stop using the tool
Air pressure too low
-
Adjust the air pressure
Worn or broken driver blade
Carry out idle driving and check
if the driver blade protrudes
from the blade guide nose
Check if the tip of the driver
blade is excessively worn or not
If the driver blade does not protrude
from the blade guide replace
Incorrect driving depth adjustment
Adjust the guide plate to the
appropriate position.
